APC Back-UPS BK500M battery pack replacement VRLA sealed lead
Replacement APC Back-UPS BK500M non-spillable sealed lead acid valve regulated UPS system batteries, AGM and VRLA that can be mounted on its side offered direct from warehouse at low cost

Below you will find all of the information on this page to help assist you in the renewal of batteries for your APC Back-UPS BK500M, it stores its required energy onboard using sealed lead storage batteries, these are used to filter the mains electrical input before outputting a clean supply without spikes and is powered by 12v cells, and comes with 1 x 12-volt batteries which is what the offer on this page is which are as required, rechargeable, they are safe to use, not-hazardous, not-spillable AGM and VRLA type batteries, more detailed information about the qualities of them will be found below

• APC Back-UPS BK500M battery

Installing the batteries is comparatively simple, refer to your manual for the procedure if you are not sure, they will come out to you almost fully charge but the system will still need to complete a service charge upon firing up, you should of course be aware that while this is happening the system will not be able to offer the full backup runtime period until its finished, we know it may not be convenient as everything is completed a rush but if you can its best to run the system without any load to start

In this UPS you could expect the batteries to last somewhere between two to five years, this will be dependant the use your put it to, ensure there is adequate ventilation around the device, do not block the vents, do not allow it to be used as a shelf to put files on, if the batteries overheat it shortens the life span, If you can keep the load below 40% the batteries will last longer, a high load will be at the expense of the overall life span of the cells

The battery type is AGM or absorbed glass mat construction, they are also valve regulated, they means they can be used in tower or rack mounted UPS systems without the fear of any leakage, they will require no maintenance throughout their entire life span and are not-hazardous so safe for use in busy data centres and of course the home office

We offer the information on this page as a guide only, if you carefully check the code on your UPS then you should be ok but look carefully as many are very similar, the batteries are environmentally friendly and recyclable, more information regarding recycling will be found at a link at the foot of this page.

Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = VRLA, AGM, sealed lead, Pb
Hot swap capable

we are offering 1 recyclable lead batteries for the APC Back-UPS BK500M the overall size of the batteries are
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5

As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below