Eaton Powerware Micro UPS 600i UPS battery pack replacement
Replacement Eaton Powerware Micro UPS 600i batteries, rechargeable valve regulated sealed lead non-spillable UPS battery backup power pack at low competitive price direct from warehouse
The following information are details to be used for replacement batteries for the Eaton Powerware Micro UPS 600i, this piece of very important equipment does the job of cleaning up the mains electrify before it hits your valuable computer equipment behind it, the cells are 12v cells, and comes with 2 x 12-volt batteries and that is what this offer is for which of course are rechargeable, sealed not-spillable safe AGM and VRLA offering a long life as these business machines will take a lot of work over the years
- Eaton Powerware Micro UPS 600i battery replacement
Even though the batteries we send to you will almost be fully charged the UPS will still need to complete a full charge, with this in mind it will mean that there is a period of time that the system is unable to offer full runtime protection while it is doing this, we know it will not always be convenient as everything is a rush now days but if you can its best to run the system without any load to start
In this kind of device you would expect the batteries to last somewhere between two to five years, this can vary greatly on conditions, ensure there is always good ventilations around the device, do not allow it to be used as a filing cabinet, if the batteries overheat it shortens the life span, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
These batteries are very tough and can be mounted on the side without any issues which means they can be used in tower or rack mountable situations, they are the recommended VRLA type and not-hazardous so safe for use in critical environments
Please note that the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look closely at the product code on your UPS then you shouldn't go wrong.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
This offer is for a set of 2 rechargeable lead acid batteries for the Eaton Powerware Micro UPS 600i the physical dimensions are as follows
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
We can offer you a 9-amp hour version of this battery size, this will give you a longer runtime between charges, a very simple upgrade with great benefits, the link to this extended version is just a little bit further down the page
