Eaton Powerware PW5119-1500i replacement UPS battery set AGM
Replacement Eaton Powerware PW5119-1500i rechargeable battery pack, valve regulated sealed lead UPS system batteries with VRLA and AGM technology at low competitive price direct from warehouse

Your UPS is there to protect vital equipment behind it, when the light is telling you it's time to replace the battery then its probably not a good idea to ignore it, it is a very easy job and is well worth the investment of a new battery to protect your valuable data, below is the details of battery replace for the Eaton Powerware PW5119-1500i, it is powered by way of internal energy storage source these batteries are used to filter the mains supply and output a clean version without any spikes the cells are 12v cells, and comes with 2 x 12-volt batteries and that is what this offer is for, they are of course recyclable as they are made from lead meaning that they are a environmentally friendly form of protection, and by fitting them in your machine you are prolonging the life of this equipment which is also a bonus rather than it ending on land fill, and why not there are years of life left in it yet.

• Eaton Powerware PW5119-1500i battery replacement

We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise

Batteries in this kind of installation will have a life span of between 2 to five years, this can vary greatly on conditions, good ventilation, if it's in a office do not use it as a book shelf, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span

These batteries are very tough and can be mounted on the side without any issues which means they can be used in tower or rack mountable situations, they are the recommended VRLA type and not-hazardous so safe for use in critical environments

Please note that the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look closely at the product code on your UPS then you shouldn't go wrong.

Voltage = 12-volts
Capacity = 18Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable

There is 2 rechargeable batteries as used in the Eaton Powerware PW5119-1500i here is the dimensions of a single battery
Length = 181mm
Width = 76mm
Height = 167mm
Battery layout - from chart below = 0

Hot swap capable, no maintenance required