APC Smart-UPS SU700NET battery replacement pack.
Replacement APC Smart-UPS SU700NET battery set, rechargeable, easy-to-fit batteries for the popular uninterrupted and surge-protected power supply system at a low cost.
There are several versions of the APC-700. To verify that you are receiving the correct pack, please inspect the label on the reverse. It will have SU700NET. If it does not, please use the search above with the proper code to obtain the correct one, or contact us for more information.
These are easy to fit, shut down all of the equipment behind it and power down the system. Remove the mains power, pull the front cover off to expose the battery door. Sometimes, these are held in place by a couple of screws, then pull the batteries out and swap them over, taking note of which wire goes where. A 10-minute job in total.
- APC SU700NET battery replacement
non-spillable. Not hazardous. No special tools required.
The best way to reset your UPS after installing batteries is to allow it to sit, connected to the mains, for 24 hours without any load. While it's not always possible, this is the best way to help prolong battery life.
Chemistry of battery: VRLA, AGM, sealed lead
Voltage of battery: 12v
Capacity of battery: 7ah
This pack contains two batteries for the APC Smart-UPS SU700NET. The dimensions of each one are as follows:
Length 151mm
Width 65mm
Height 94mm.
