APC DL2200RM13U UPS battery replacement pack VRLA sealed lead
Replacement APC DL2200RM13U computer UPS battery pack, valve regulated sealed lead acid rechargeable absorbed glass mat batteries that will not spill offered at low prices direct from warehouse
You have installed your UPS to protect the vital equipment behind it, when the battery light or that annoying alarm noise is telling you it's time to replace them then it's wise not to ignore it, it is a very easy job and is well worth the investment of a new battery to protect your valuable data, below is the details required to replace for the APC DL2200RM13U, the power supply utilises these storage batteries to smooth out and clean up the mains electricity that is inputted by passing it through the cells before it reaches the equipment behind it, flattening out the spikes, they are 12-volt cells, this system comes with 8 x 12v batteries and that is what we are offering on this page which are rechargeable, safe and not-hazardous non-spillable AGM and VRLA type of cell with deep cycle properties which would be needed in this type of equipment
Installing the batteries is not a difficult task, you can refer to your user manual for the method if unsure, once they have been fitted your system will fully charge them, despite the fact they will come out to you almost fully charged it will still need to complete this, so it will follow that there will be a short period of time where you do not have the full runtime protection that your UPS could possibly offer you until it has completed this operation, you probably just want to install and leave the system to its devices but its best to run the system without a load to so it can properly reset
A reasonable life span of batteries is between two to five years, this will however differ quite a lot from user to user depending on the use, ventilation is important, best placed to site would be in an air conditioned communications room, batteries will in general get hot if the heat cannot disperse it will shorten life span, to get a long battery life you should try to keep the load below 40%, if you have added more devices over time this may have crept up, its capable much more but the pay off will be battery life so it's a balancing act
These batteries are absorbed glass mat, AGM and valve regulated sealed lead acid or VRLA for short, they require no maintenance and due to their internal chemistry can be mounted on the side in rack mounted or tower UPS systems without the fear of leakage, they are not-hazardous so can be used in busy data centres, hospitals and of course the home office.
Check the code on your system carefully so you order the right battery set, so many of the codes are very similar so it's easy to make a mistake, if still unsure have a look at the batteries you have already, the dimensions will help eradicate issues as these are also listed on the page, the batteries are made mainly from lead and recyclable, more information on recycling can be found at the foot of this page.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA, Pb
Hot swap capable
There is a total of 8 rechargeable batteries for the APC DL2200RM13U UPS we have mentioned the size below of each battery for your convenience
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
If you prefer we can offer this battery in a 9Ah format, it's the same dimensions and will slip straight in, a very easy upgrade that will offer you more runtime, the link to it will be just a little bit further down the page
