IBT BT1.3-6 6v 1.2ah battery replacement sealed lead AGM VRLA.
Replacement IBT BT1.3-6 battery pack, 6V sealed lead-acid AGM and VRLA 1.2Ah rechargeable batteries. They will not leak, and they are offered at a low price, direct from the UK warehouse.
These compatible IBT BT1.3-6 6V 1.2Ah batteries are valve-regulated, sealed lead-acid types. They will not leak and can be mounted on the side, often seen in alarm systems as well as portable medical monitoring equipment if being used in something with its always-connected charging circuit, for example, a commercial or residential alarm system, because the on-board charger looks after the charging of the battery, it would not be unusual for the battery to last more than 10-years. However, as it is in such an essential piece of equipment, it should be changed before then. When going into something that requires human intervention to plug it into the charger, they will last much less, as the battery will typically be run down much more between charges, shortening the lifespan.
After placing your order and upon receiving your new IBT BT1.3-6 battery pack, you may note that they have a good charge. However, you should still charge them thoroughly before using them for the first time (you do not need to do this if going in something like an alarm system with its always-connected charger as discussed above, as this will do it all for you), there should be no need for many hours, it will probably not take very long at all, just until your charger indicates they are ready, this will, of course, depend on the charger capabilities, while you may well be tempted just to fit them and go without charging if it's going in a portable device its worth completing the charge first.
You probably will not notice, but it will take up to 10 charges and associated use in your device before the IBT BT1.3-6 replacement batteries can take a few capacity charges. This is normal. You should fully charge your batteries as soon as possible after every use. If being used in a portable device, do not leave them sitting in a semi-discharged state for any period unless necessary.
We have heard of people trying to extend battery life by running them down. Fully discharging your new batteries will reduce their overall lifespan, and they will need to be replaced sooner; this will cost you money in the long run. These batteries need to be kept charged, so if they are not used for any reason, ensure they are charged beforehand and every four weeks, but do not leave them on a charger for more than twenty-four hours.
These IBT BT1.3-6 replacement batteries are valve-regulated and AGM (absorbed glass mat). No liquid is needed, as the acid is held within the glass mat, which means they will not spill and are not hazardous, so safe for use around the home and/or portable equipment. They are deep-cycle, which would be required in this sort of application.
So many battery codes are almost the same. You should carefully check them before ordering to ensure you get a suitable pack. If in doubt, look at your old one and take note of the dimensions and anything written on the side. This will always be the best information to have. We have also included the measurements on the page so you can confirm them before ordering. As these 6V 1.2Ah batteries are made of lead, they are recyclable and environmentally friendly. More information about recycling can be found on a link at the foot of this page.
Voltage = 6v
Capacity = 1.2Ah @20Hr
Chemistry = Pb, valve-regulated lead acid, VRLA, AGM.
The physical size of this IBT BT1.3-6 replacement battery is as follows:
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches.
