R&D 5746 rechargeable 6-volt 1.2ah battery replacement AGM VRLA
Replacement R&D 5746 battery set, valve regulated safe non-spillable 6-volt 1.2ah rechargeable batteries, they are AGM and VRLA at low competitive price direct from warehouse

On this page you will find we have listed all of the required data to support your consideration of a purchase of a new replacement compatible battery for the R&D 5746, with a capacity of 1.2-amp hours, these 6-volt cells are also capable of deep cycling, as you would expect they are rechargeable and not-hazardous, they will not spill so safe to be handled and for use indoors, they are also recyclable and environmentally friendly, more information on recycling can be found on our recycle page

• R&D 5746 battery replacement

When your order is delivered to you your new batteries will be almost fully charged, but regardless of this you should still complete a charge them before first use, however if it's a battery backup for something that's always connected to the mains like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, your charger will indicate to you when it has completed a charge, it will probably not take very long depending on the charger, the light will generally change to indicate its ready, you may well just want to fit them and use the equipment, but do not miss this first step if needed, it's worth waiting until the first charge has completed and it may well contribute to over life span

If you are a normal user then you will probably not even notice it but it can take up to ten charges and associated use in your device before its capable of accepting a full capacity charge, this is all part of the conditioning process and quite normal, you should fully charge your batteries as soon as you can after every use if being used in a portable device, do not leave them sitting in a semi discharged state any period unless necessary, never go out of your way to deliberately discharge fully, this will only reduce overall life span, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours

The battery type is AGM which is short for absorbed glass mat construction, they are also valve regulated, they means they can be used around the home or in portable devices without the fear of any leakage, with deep cycle properties that this type of installation would require, they will require no maintenance throughout their entire life span and are not hazardous

So many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, this 6-volt 1.2ah battery is as you would expect recyclable, more detailed information on recycling can be found at the foot of this page

Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = AGM, VRLA, Pb

We are offering a total of 1 quality lead acid batteries for the R&D 5746 the overall size of the batteries are
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1