Power PM12-18 battery 12-volt 18-amp replacement sealed lead AGM
Replacement Power PM12-18 12-volt battery pack, rechargeable sealed lead acid, safe non-spillable valve regulated VRLA 18-amp hour batteries with advanced AGM technology at low competitive cost
This page offers more informative data and dimensions of a new replacement battery for the Power PM12-18 they are 12v 18ah sealed lead type, valve regulated and rechargeable, AGM and VRLA they can be mounted on the side and will not spill so can be safely used in portable devices and capable of deep cycles, often seen in things like car and commercial jump start packs, mobility scooters, UPS systems and many others
This is a AGM and VRLA battery, it is deemed safe to use indoors as it is not-hazardous, no spillage, it needs no maintenance throughout its life, except of course charging, no topping up with fluid, will not leak, can be mounted on its side, often used in portable devices as well fixed machines that require a reliable long lasting battery backup
Do not allow the battery to become fully discharged, it will only shorten its life and with certainly if you leave it is a discharged state, charge when you receive it and if not being used every 4-weeks, charge after each and every use, the only time this wouldn't be required is if the battery was going in something with its own charging circuit that is always connected to the mains, like a UPS battery back up, it is essential for a longer battery life to keep it charged, this will save you money in the long run
We assume that you have already had a good look at your old battery the cod, dimensions and confirmed this compatible one is a suitable replacement, if not then do so, the data listed here is compiled from our own resources but it should always be checked, it will be a lot quicker than you ordering the wrong one as this is only a guide the physical dimensions are listed here so you can compare before ordering
Voltage = 12-volts
Capacity = 18Ah @ 20Hr
Chemistry = Sealed lead, AGM, VRLA
In this pack there is one ready to install batteries for the Power PM12-18 the dimensions of the individual battery pack are as follows
Length = 181mm or 7.12-inches
Width = 76mm or 2.99-inches
Height = 167mm or 6.57-inches
You might also want to consider a 22ah battery, it has the same physical dimensions and depending on your requirements could be a very easy upgrade as it will go into the same space, this extra 4-amps is the energy storage of the battery this means it will run longer between charges, if it was fitted to a electric vehicle it would mean more miles for every charge, there is a link to the alternative longer running ones below
