Skip to Main Content

Union MX-12040 12v battery replacement sealed AGM VRLA

£34.94 inc. VAT

Images for assistance only.
Share This Product
  • Model:BT1242-42545
  • Battery Charge:Rechargeable
  • Battery Voltage:12.00 Volts
  • Battery Capacity:4.50 Ah
  • Battery Chemistry:AGM
  • Condition:New
  • Pack Contains:1
  • Shipping Weight:1.65 Kilos

Union MX-12040 12-volt battery replacement sealed AGM VRLA
Replacement Union MX-12040 battery pack, rechargeable 12v 4.5ah sealed lead acid, safe non-spillable can be used in portable devices as well as UPS systems, valve regulated VRLA batteries with advanced AGM technology at low competitive cost

The following information has been compiled to assist you to make a more informed decision on the purchase of a new replacement compatible battery for the Union MX-12040, which are 12-volt and 4.5ah these are seen in quite a few applications from portable equipment and uninterruptible power systems as power backup and or course capable of deep cycling, these are of course as would clearly be needed rechargeable, they are non-spillable so safe and not-hazardous, can be stored and used indoors without fear of leakage, the cell structure is a composite of lead formed as AGM and VRLA

  • Union MX-12040 battery replacement

After placing your order and upon receipt of your new battery pack you may will note that they have a good charge in them, but you should still charge them fully before using for the first time, however if it's a battery backup for something that's always connected to the mains like an alarm or UPS system then you do not need to charge it first as the system will do that for you, the charger will have LED lights which will indicate whether it is still charging or not, you only need to charge them until they are ready, probably not very long at all, you might just want to use them, but that would be unwise, unless as stated above, missing out on charging them first could shorten overall life expectancy

It's not always apparent but it will take up to ten charges combined with use in your chosen device before a full capacity charge can be achieved, this is just a normal part of the conditioning process, after you have used your more portable equipment you should get a charge back into it as soon as you are able, do not leave it sitting around in a partially discharged state for any longer than absolutely necessary, you should never deliberately go out of your way to try fully discharge the batteries, it will not reset them, this will only reduce its life span and cost you money in the long run, it is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours

The battery type is AGM which is short for absorbed glass mat construction, they are also valve regulated, they means they can be used around the home or in portable devices without the fear of any leakage, with deep cycle properties that this type of installation would require, they will require no maintenance throughout their entire life span and are not hazardous

We have provided the information here only as a guide, you need to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the wisest thing to do, these 12v 4.5ah batteries are mainly constructed using lead or Pb and as such can be easily recycled, more information on recycling can be found at the foot of this page

Voltage = 12-volts
Capacity = 4.5Ah @20Hr
Chemistry = VRLA, AGM

In this pack there is 1 batteries to replace the Union MX-12040 the overall dimensions of each battery are
Length = 90mm or 3.54-inches
Width = 70mm 2.75-inches
Height = 101mm or 3.97-inches
Battery layout - from chart below = 1

Union MX-12040 sealed lead battery terminal layout guide

We also do this physical size battery as a 5ah, it will slip straight in and offer you more energy per charge so a very easy upgrade, the link to them will be just a little bit further down the page


Frequently Asked Questions

Ask us a question

There are no Videos for this particular Product.
View our other help, technical, installation and information videos.

Installation Videos

We do have other Videos, subscribe to our Youtube Channel using the Button below.
Supplementary Files: None available

  • 98% of orders shipped same day for next day working day delivery in UK Mainland
  • FREE Delivery on orders of £45 and over in most of UK Mainland
  • We ship Worldwide, add to cart for delivery cost
  • You can return any order for any reason, in resaleable condition, within 14 days
  • Our full delivery and returns details can be viewed in the footer
Explore
0 item(s), £0.00

0 items