Power PM12-1.3 rechargeable 12-volt 1.2ah battery replacement AGM
Replacement Power PM12-1.3 rechargeable battery pack, valve regulated sealed lead 12-volt 1.2-amp hour batteries with VRLA and AGM technology, seen in alarm systems or portable equipment, at low competitive price direct from warehouse
Below you should find we have listed all of the relevant information on this page which should help assist you in the renewal of a compatible battery for your Power PM12-1.3, with a capacity of 1.2-amp hours, these 12-volt cells are used in many types of application such as portable medical equipment, emergency lighting and even home alarm systems they are also capable of deep cycling, being AGM and VRLA they are rechargeable, they are safe to be handled and to use indoors or in portable devices, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- Power PM12-1.3 battery replacement
After you have unpacked your new battery order from us you will note that they will have a good charge in them, regardless of this you should still complete a full charge before first use, the only time you do not need to do this is if it's going into something with its own always connected power supply, for example a alarm system, as this will do the job of charging for you, it shouldn't take long, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, this first step is important so do not ignore it, unless as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span
It's not something that most will even notice but it will take a few charges and use in the equipment before a full capacity charge is reached, it's all part of the normal conditioning process, when you have used your portable devices then put the batteries back on charge, you do not want to allow them to sit in a partially discharged state, never go out of your way to deliberately discharge fully, this will only reduce overall life span, if there are extended periods where you are not using the batteries you should remember to recharge every four weeks and never put them away discharged, even partially, do not leave on the charger for more than 24-hours at a time
These 12-volt batteries are AGM ( absorbed glass mat ) and VRLA ( valve regulated lead acid ) they are deep cycle and not-hazardous so suitable for use indoors or in portable devices, they will not leak all features that make them useful for use in this kind of application, they of course do not require any maintenance
So many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, This 12-volt 1.2ah battery is as you would expect recyclable, more detailed information on recycling can be found at the foot of this page
Voltage = 12-volts
Capacity = 1.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
There are a total of 1 batteries to replace the Power PM12-1.3 the dimensions of the individual battery pack are as follows
Length = 97mm or 3.81-inches
Width = 43mm 1.69-inches
Height = 52mm or 2.04-inches.
