Eaton Pulsar EX1000, EX1000-RT UPS battery replacement pack AGM
Replacement Eaton Pulsar EX1000, EX1000-RT sealed lead battery pack, rechargeable UPS system valve regulated batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost

Eaton was founded in America with a worldwide distribution network including Europe below you will find details of the battery you need for your Eaton Pulsar EX1000, EX1000-RT, the energy that is required for functioning is stored directly onboard it takes the mains supply and passes it through the batteries and is powered by 12v cells, and comes with three batteries and that is what this offer is for these are rechargeable, non-spillable safe AGM, VRLA and capable of deep cycling which is vital in this sort of installation where they are constantly being used 24-hours a day

• Eaton Pulsar EX1000 battery
• Eaton Pulsar EX1000-RT battery replacement

The batteries will come out to you almost fully charged, but the system will still want to finish off the full charge, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise

In this kind of device you would expect the batteries to last somewhere between two to five years, this will however will vary greatly depending on the conditions or storage and overall use, using the system as part of the office furniture is not the best idea, it needs ventilation, the batteries will get very hot as they are working hard 24-hours a day, the more heat the shorter their life, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span

These batteries are valve regulated sealed lead or VRLA, they will not spill so can be mounted on the side without fear of leakage, they can be used in rack or tower modules, they are not-hazardous so safe for use in mission critical environments including busy data centres or hospitals

Ensure that you order the right battery by checking the code on your UPS and comparing it to the information here, many are very similar, these hot swap capable batteries are recyclable, more information on this can be found at the bottom on this page on our recycling link.

Voltage = 12v
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable

There is a total of three recyclable lead batteries for the Eaton Pulsar EX1000, EX1000-RT we have mentioned the size below of each battery for your convenience
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5

We are also able to offer this size battery as a 9ah version, its exactly the same physical size and will slip straight in to the same cavity except it will offer a longer runtime and will probably last longer overall saving you money in the long run, link to this alternative is a bit further down the page