Emerson PSA 1000MT3 replacement UPS battery set sealed lead AGM
Replacement Emerson PSA 1000MT3 rechargeable battery pack, valve regulated sealed lead UPS system batteries with VRLA and AGM technology at low competitive price direct from warehouse

Please find the information on this page to help you make a decision for a new set of batteries for the Emerson PSA 1000MT3, the onboard energy storage which give you the required runtime back up facility also helps to filter and smooth out the mains input supply before releasing a clean version on to your valuable equipment behind it without surges and is powered by way of 12-volt cells, this system comes with 2 x 12v batteries and that is what we are offering on this page, they are the required rechargeable type of battery, not-hazardous and will not spill, safe to mount on the side, AGM and VRLA, more information about these chemistries will be found below

• Emerson PSA 1000MT3 battery replacement

The new batteries that we dispatch out to you will be almost fully charged but the system will still need to fulfil and complete a service charge after installing, until this charge has completed you will not have the full runtime protection available, while it may never be convenient in this fast moving world it would still be best to run without any load to start so the system can fully reset itself to the new battery energy level

Fitted in a UPS you could expect a battery life span of between 2-5 years, this will however vary somewhat depending on the general position of the item and overall use, ventilation is important, best placed to site would be in an air conditioned communications room, batteries will in general get hot if the heat cannot disperse it will shorten life span, If you add more devices over time keep an eye on the load, if you can keep it below 40% it will last longer, while its more than capable of going higher it will be at the expense of the battery life

These batteries are absorbed glass mat, AGM and valve regulated sealed lead acid or VRLA for short, they require no maintenance and due to their internal chemistry can be mounted on the side in rack mounted or tower UPS systems without the fear of leakage, they are not-hazardous so can be used in busy data centres, hospitals and of course the home office.

Many codes on UPS systems are very similar, carefully check them before ordering to ensure you are getting the right pack, the batteries themselves are recyclable, more detailed information about recycling lead batteries can be found on a link at the foot of this page

Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM
Hot swap capable

In this set you will find a quantity of 2 rechargeable batteries as used in the Emerson PSA 1000MT3 UPS we have mentioned the size below of each battery for your convenience
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5

As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below