PowerWalker VI 850 SE IEC, 10120049 battery replacement
Replacement PowerWalker VI 850 SE IEC, 10120049 UPS battery pack, rechargeable batteries for the PowerWalker computer battery backup uninterrupted power supply, no maintenance required.

You are probably visiting this page because your UPS is bleeping away with a not so pleasant tone stating it would like new batteries, this is not something to be wary of but do not delay as its do a job of protecting valuable data behind it, it's not a difficult job and will need to done every few years unless you have money to throw away and buy a new unit, below you will find details of the battery for your Powerwalker VI 850 SE IEC VI 850 SE IEC, this piece of very important equipment cleans up the mains electrify before it hits your valuable computer equipment behind it, the cells are 12-volt and comes with 2 off, 12-volt batteries, as you would expect they are rechargeable and as they are also recyclable to give them a long life and of course environmentally friendly, more information on recycling can be found on our recycle page

• Powerwalker VI 850 SE IEC battery

AGM batteries suspend the electrolyte within a glass mat layer meaning that there is no liquid to spill out, so they can quite safely be mounted on the side without fear of spillage, they are vented but if you keep overcharging them in a UPS when they should have been changed for new ones then they could possibly warp slightly, so if your machine requires new batteries get them sooner rather than later else you may have trouble getting them out of the case and of course if the batteries are not doing the job they are meant to do you run the risk of not having full protection for your computer equipment

Check the code on your PowerWalker UPS to ensure you are ordering the correct battery set, the size of the batteries are also specified below if you are unsure, they are hot swap capable and require no maintenance, they will be delivered in a almost fully charged state, after fitting allow the system time to fully charge the batteries before relying them fully for runtime, if you can it would be preferred to do this without any load to start, we know that this will not always be convenient but if circumstances allow it then do so.

Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA

There is a total of 2 batteries for use in the Powerwalker VI 850 SE IEC VI 850 SE IEC the physical dimensions are as follows
Length = 151mm
Width = 65mm
Height = 94mm

We are also able to offer this size battery as a 9-amp hour version, its exactly the same physical size and will slip straight in to the same cavity except it will offer a longer runtime and will probably last longer overall saving you money in the long run, link to this alternative is a bit further down the page