RBP0106 sealed lead battery pack for PR1000ELCD CyberPower UPS
Replacement RBP0106 sealed lead rechargeable battery pack for CyberPower PR1000ELCD UPS machine, delivered from the warehouse at low cost
For stabilised AC power output with Pure Sine Wave to ensure high power quality, the Professional Tower Series, designed for computer rooms and server rooms, uses a line-interactive topology with the Automatic Voltage Regulation (AVR) function. The battery packs on the UPSs are hot-swappable, allowing maintenance to be performed without interrupting power. The products' compatibility with power management software allows for simple control and monitoring of the UPS system.
- CyberPower PR1000ELCD battery
- CyberPower RBP0106 battery
Pack of two batteries for easy installation into PR1000ELCD CyberPower UPS system
Maintenance for new RBP0106 battery in PR1000ELCD UPS
According to CyberPower recommendations, these premium replacement batteries are made for use in uninterruptible power supply devices and should last between two and five years. The range is so broad because it all depends on how well-maintained and how hard the batteries are pushed. There are a few ways you can assist the UPS, which naturally has its own charging system. First, run the UPS without any load after installation. Additionally, avoid using the UPS as a table. It is a good idea to keep the vents open and in a well-ventilated area. Last but not least, if at all possible, try to keep the load below 40%.
RBP0106 and PR1000ELCD Installation
The steps for replacing the batteries in your PR1000ELCD UPS are provided below:
First, disconnect your device from the power source and turn off and unplug all connected devices. Pull out both round knobs to release the battery compartment after removing the UPS's front panel. Remove the batteries, disconnect the wires, replace them with new batteries, and reconnect the wires. Reverse everything and secure the cover once more.
The user manual for the PR1000ELCD will be available for download on our Downloads tab and will contain more in-depth information.
Voltage: 12v
Capacity: 12ah @ 20Hr
Terminals: T2 6.35mm Spade
Chemistry: AGM, VRLA, Sealed Lead, Pb
The dimensions of each battery in this pack of two is below, it should fit pretty snug in the UPS
Length = 151mm
Width = 99mm
Height = 94mm
