Electric mobility Butler battery replacement disabled VAT relief 12v x2
Replacement Electric mobility Butler non-spillable sealed lead acid valve regulated 12-volt mobility batteries, AGM and VRLA disabled VAT relief available, offered direct from warehouse at low cost
Below you will find we have listed all of the information on this page to help assist you in the renewal of a set of mobility batteries for your Electric mobility Butler, it stores its required energy onboard using sealed lead storage batteries, these are 34-amp hour batteries, it uses 2 x 12-volt batteries, they are replacements for them, of course they are capable of deep cycling and rechargeable, two very necessary requirements in this type of installation, also they are non-spillable and not-hazardous so safe for use indoors or indeed the pavement and travelling in a electric vehicle, the cells are AGM and VRLA of which more information can be found further down the page
- Electric mobility Butler battery replacement
After you have unpacked your new battery order from us you will note that they will have a good charge in them, but you still need to complete a full charge before first use, there should be no need for many hours, just until your charger indicates they are ready, this will of course depend on the charger capabilities, do not just fit them and roll without this initial charge, it will help to extend the battery life overall
It's not always apparent but it will take up to ten charges combined with use in your device before a full capacity charge can be achieved, this is the normal part of conditioning, letting the batteries sit in a discharged state, even partially is not a good idea, as soon as you have used them put them back on charge, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, if for any reason you are not using them for long periods then you should recharge every four weeks but do not leave on the charger for more than 24-hours at a time
These 12-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or on the road or pavement without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not-hazardous so safe for use in travel including aeroplanes but you should check with your airline at time of booking
You should confirm the code on your mobility equipment carefully, there are many that are very similar so you order the right battery set, if in doubt look at you old batteries, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions of the battery to make certain, these batteries are recyclable the main component is lead which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 12-volts
Capacity = 34Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM
In this pack there is 2 quality batteries for the Electric mobility Butler the physical size of the individual batteries are as follows
Length = 195mm or 7.67-inches
Width = 130mm 5.11-inches
Height = 156mm or 6.14-inches
Battery layout - from chart below = 1
If you prefer we can offer this mobility battery in a 38Ah format, it's the same dimensions and will slip straight in, a very easy upgrade that will offer more miles per charge, the link to it will be just a little bit further down the page
