Everest & Jennings Hot wheels battery replacement VAT relief mobility
Replacement Everest & Jennings Hot wheels mobility sealed lead battery pack, rechargeable system valve regulated batteries, disabled VAT relief available, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Below you will find we have listed all of the information on this page to help assist you in the renewal of a set of mobility batteries for your Everest & Jennings Hot wheels, the power supply uses these storage batteries, they are 34-amp hour batteries, it uses 2 x 12-volt batteries, they are replacements for them, being AGM and VRLA they are rechargeable along with deep cycle capabilities as would be needed in this type of use, they are safe to use indoors, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- Everest & Jennings Hot wheels battery replacement
When you receive your order from us your new batteries will be almost fully charged but you will still need to complete the charge before first use, you do not need to leave it on for hours on end, just until the charger has indicated that it has finished, you may well just want to fit them and use the equipment, but do not miss this first step, it's worth waiting until the first charge has completed and it might contribute to over life span
It's not something that most will notice but it will take a few charges and use in the equipment before a full capacity charge is reached, it's part of the normal conditioning process, ensure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, discharging the batteries fully will only reduce their life expectancy, it will do them no good and will cost you money in the long run, there may well be extended periods where the batteries are not being actively used, if so ensure they are charged fully beforehand and then recharged every four weeks but do not leave on the charger for more than 24-hours at a time
These 12-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or on the road or pavement without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not-hazardous so safe for use in travel including aeroplanes but you should check with your airline at time of booking
We have provided the information here only as a guide, you need to check the code on your mobility device carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the dimensions so you can make sure you are ordering the correct pack, looking at your old batteries, taking note of the dimensions and anything that may be printed on the side is probably the wisest thing to do, as the batteries are made of lead they are recyclable and environmentally friendly, more information about recycling can be found on a link at the foot of this page
Voltage = 12-volts
Capacity = 34Ah @20Hr
Chemistry = AGM, VRLA, Pb
There is 2 rechargeable batteries as used in the Everest & Jennings Hot wheels here is the dimensions of a single battery
Length = 195mm or 7.67-inches
Width = 130mm 5.11-inches
Height = 156mm or 6.14-inches
Battery layout - from chart below = 1
we are also able to supply this physical size battery with 38ah, this extended runtime version will slip in the same cavity as it's the same dimensions and offer you more miles per charge, link to this option will be just a little bit further below
