Piller Technology 4 Wheeler 409 Battery Replacement Set.
Replacement Piller Technology 4 Wheeler 409 mobility battery pack, rechargeable sealed lead non-hazardous 12v batteries that will not leak, VRLA, AGM at low competitive prices.
Below you will find we have listed all of the information on this page to help assist you in the renewal of a set of mobility batteries for your Piller Technology 4 Wheeler 409, your electric vehicle utilises the batteries to store energy they are 35ah batteries, it uses two 12v batteries, they are replacements for them, being AGM and VRLA they are rechargeable along with deep cycle capabilities as would be needed in this type of use, they are safe to use indoors, also recyclable the main component of the cells is lead. Hence, they are very easily recycled and environmentally friendly. More information can be found on our recycling page.
- Piller Technology 4 Wheeler 409 battery replacement
After you have unpacked your new Piller Technology 4 Wheeler 409 battery order from us, you will notice that it will have a reasonable charge. However, you still need to complete a full charge before using it for the first time. The charge time will depend on your charger; leave it on until the indicator shows it's finished. Do not just fit them and roll without this initial charge; it will help to extend the battery life overall.
it may well take several full charges and alternating use in your Piller Technology 4 Wheeler 409 for the battery to condition and be able to take a full capacity charge, this is quite normal, as soon as you after each use put them back on charge, do not allow them to sit in a discharged state, do not try to discharge the batteries fully, it will reduce the lifespan and cost you money in the long run, it is essential to keep a charge in the batteries for long life, so if there is any period of time where they are not being used then charge before hand and top this up every four weeks but do not leave on a charger for more than 24-hours.
These Piller Technology 4 Wheeler 409 batteries will require no general maintenance, no topping up with fluid as it has none, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or on the road and for travelling by air, but you should check with your airline when you book your ticket.
We have provided the information here only as a guide, you need to check the code on your Piller Technology 4 Wheeler 409 carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the dimensions so you can make sure you are ordering the correct pack, looking at your old batteries, taking note of the dimensions and anything that may be printed on the side is probably the wisest thing to do, these batteries are recyclable the main component is lead which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link.
Voltage = 12v
Capacity = 35Ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM.
There are two batteries for use in the Piller Technology 4 Wheeler 409. The physical dimensions are as follows:
Length = 195mm or 7.67-inches
Width = 130mm 5.11-inches
Height = 156mm or 6.14-inches.
We can also offer this physical size battery set in 38Ah, which will provide you with more miles per charge. As it has the exact dimensions, it will fit straight into the same space. This can be selected in the easy upgrade above.
