Pride mobility 6000Z (group 4) battery set disabled VAT relief mobility
Replacement Pride mobility 6000Z (group 4) mobility battery pack, rechargeable sealed lead non-hazardous 12-volt batteries that will not leak, disabled VAT relief available, VRLA, AGM at low competitive prices
The following information has been compiled to help you consider the purchase of new replacement mobility batteries for the Pride mobility 6000Z (group 4), the energy required for use is stored in deep cycle batteries, they are 34-amp hour batteries, it uses 2 x 12-volt batteries, they are replacements for them which are as would be needed in such an application rechargeable, they are of course non-spillable and not-hazardous so safe to use indoors, they have a AGM and VRLA type of cell which is what should be fitted in this type of electric vehicle, more information on the chemistry will be found below
- Pride mobility 6000Z (group 4) battery replacement
Upon receipt of your mew battery order you will note that they have a good charge, but you will still need to charge them before using for the first time, just charge them until your charger LED lights indicate that they are ready, do not be impatient, wait until this first charge has completed before thinking about using the equipment, it will contribute to overall battery life
You probably will not notice but it will take up to ten charges and associated use in your device before the batteries are capable of taking a few capacity charge, this is normal, allowing your new batteries to sit without charge is not a good idea, as soon as you have finished using it put it back on charge, do not attempt to discharge the batteries fully, this can reduce life span quite drastically so cost you money in the long run, If there are extended periods where the batteries are not being used then ensure they are fully charged beforehand then recharged every four weeks but you should not leave on the charger for more than 24-hours
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak and not-hazardous so suitable for travelling, there is not maintenance required, except of course charging which we have covered on this page, both VRLA and AGM
Please note you should use all the information on this page only a guide, while we have tried here to assist you in getting the correct batteries for your mobility equipment, it should be noted that there are many very similar codes, if you are not sure you should always double check what you have before ordering, this may also give you the opportunity to see how easy it is going to be to change the batteries, take note of the dimensions and anything written on the side of them, all the physical sizes of the batteries are listed on this page, these batteries are made mainly of lead which is easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 12-volts
Capacity = 34Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
There is 2 rechargeable and recyclable batteries for the Pride mobility 6000Z (group 4) the physical size of the individual batteries are as follows
Length = 195mm or 7.67-inches
Width = 130mm 5.11-inches
Height = 156mm or 6.14-inches
Battery layout - from chart below = 1
If you would like a easy upgrade we can offer this size battery with 38ah, this means it will run longer on a single charge and supply more miles, it's the same dimensions so will fit in the same opening, link to this option can be found below
