APC SRT192BP SRT192RMBP battery module UPS SRT5 SRT6 replacement
Replacement battery module for APC SRT192BP and SRT192RMBP to fit SRT5 and SRT6 range of UPS machines, easy replace pack of 32 AGM sealed batteries
The SRT192BP and SRT192RMBP is an external extended battery module that fits a range of different UPS machines from the SRT5 and SRT6 range. The addition of the number two at the end means its for the SRT8 and SRT10 range however the batteries are the same. These are powered by a set of thirty two (two lots of RBC140) batteries that will eventually need replacing, which is fairly simple and quick to do while using all your old connections and wires. On offer here is a set of the total amount of batteries needed to replace one whole external battery pack. Having this extended module greatly increases the length of time the UPS can do its job.
It is important to replace your batteries when the machine tells you, what is the point of having a UPS like this if it’s not going to fulfil its job? Uninterruptible power supply devices, or UPS for short provides battery backup power when the flow of electricity drops to an inadequate voltage or stops completely, therefore protecting your valuable data from loss or corruption.
- APC SRT192BP battery module
- APC SRT192RMBP battery module
- APC SRT192BP2 battery module
- APC SRT192RMBP2 battery module
This battery pack is suitable to replace the extended module batteries mentioned above, wpould be a good idea to replace them at same time as you are replacing main UPS ones:
Tips on looking after your new SRT192BP batteries
Batteries installed into UPS systems typically have a life of about two to five years depending on use. Obviously the UPS has its own charging cycle which is a good start as the computer will maintain the correct voltage better than a human ever could, however there are a few things you can do to help. If you are running a machine of this size one would assume you already know these tips but they are listed here anyway. Firstly, after installation you should allow the UPS to run without load as this will help them reset. You can also ensure it has good ventilation, is clear of any dust and stored in a climate controlled area. If you can use less than 40% load this will also be beneficial.
Installation of SRT192RMBP batteries
In our downloads section on this page you will find a Smart-UPS On-Line external battery pack installation guide for SRT192BP, SRT192RMBP, SRT192BP2 and SRT192RMBP2 modules. Detailed information and exact steps on how to remove your external battery module and change over your batteries can be found there however if you are unsure then please seek advice from a professional.
Recycle your old SRT192BP2 batteries
These batteries are sealed lead AGM and safe to be mounted on their side which means they are (including your old ones) environmentally friendly and able to be recycled. At the end of their life please direct them to your local centre for recycling where they can be turned into something new and continue on their green life.
Voltage: Each battery is 12v
Capacity: 5Ah
Chemistry: AGM, sealed lead
The dimensions of each battery in this pack of 32 for the SRT192BP and SRT192RMBP are as follows:
Length: 90mm
Width: 70mm
Height: 101mm
